PRODUCTS & SOLUTIONS

    CT/C 200

    Dimensions

    length a) mm 732 - b) mm 915

    length upon request from continuous production process.

    Thickness

    from mm 0,6 to mm 1,0 - also non-standard on request.

    Materials

    Galvanized steel, coated or laminated; stainless steel, copper:
    - steel in compliance with the UNI EN 10147 Fe E 250 G type, available in hot galvanized with "sendzimir" process, pre-painted or plasticized galvanized.
    - Aluminum alloy 3103 H16 conforming to the UNI 9003/3 Standard or according to UNI 10372, available natural or pre-painted.
    - AISI 304 stainless steel, 2B finish, compliant with UNI 10372 Standards.
    - CORTEN.
    - Copper conformity with standards UNI EN 1172 - UNI 10372.

    LOADS TABLE

    PITCH BETWEEN SUPP.(mm)
    SHEET TICKNESS(mm)
    MATERIAL
    MAXIMUM UNIFORMLY DISTRIBUTED LOAD (daN/m2) - DEFLECTION ≤ 1/200 L
    Panel
    Thickness
    (mm)
    MaterialSheet
    thickness
    (mm)
    Pitch 'L' in meters between the supports
    1,00 1,50 2,00 2,50 3,00 3,50 4,00
    0ACCIAIO0,6 679 302 150 76
    0ACCIAIO0,7 798 355 176 90 52
    0ACCIAIO0,8 917 407 202 103 60
    0ACCIAIO1,0 1156 513 255 130 75
    MAXIMUM UNIFORMLY DISTRIBUTED LOAD (daN/m2) - DEFLECTION ≤ 1/200 L
    Panel
    Thickness
    (mm)
    MaterialSheet
    thickness
    (mm)
    Pitch 'L' in meters between the supports
    1,00 1,50 2,00 2,50 3,00 3,50 4,00
    0ACCIAIO0,670731417611378
    0ACCIAIO0,78483772121359462
    0ACCIAIO0,899244024815811071
    0ACCIAIO1,012845703212051429060

    Insights on the test report

    (Note) The report test given, is provided for information purposes only. Values and formulas should not be used to determine or calculate the flow rate of the panel. It is the responsibility and care of the customer and/or designer to draft appropriate calculations with specific reference for individual uses. The thicknesses and quality of steel defined in the report test above, does not represent a standard of product as the combination of thicknesses and materials is determined by the customer according to their technical requirements, therefore the customer and/or the designer are required to specify thickness, quality and type of materials that the producer will use in the construction of the panels.

    © 1999-2019, ISOLPACK SpA. All rights reserved.